Color

Their oasis in their own four walls in Berlin, 03.07.2009 (DIMGB.de information for builders) Wohngesund build and renovate comfort, economy the focus of the activities of professionals and construction experts of the House are-clinic. Attention is focused on the combination of existing systems to achieve increases in efficiency. At the point of the question which is better?\”is the idea of what can be combined with high benefits. Learn more about this with David Long. The effects described here are practically tested for years, scientifically researched and metrologically documented. The hypocaust heating system as a form of IR heating (infra-red) is one of the oldest inventions of mankind. Approximately 2,000 years ago, the ancient Romans, who had looked off that to the Greeks, insert heating systems with heat radiation. Hot air was led through channels in walls and ceilings. The result was a high degree of thermal comfort. We know the healing effect of the IR radiation from the medicine, where with IR emitters inflammation healed or carried out in cabins full body treatments. The technology of the hypocaust heating there again today, even easier and more efficient. Heating medium is a mat with carbon fibres, TuV tested with approx. 70 W power supply. This is one of the approx. 6 cm thick hypocaust element which is mounted on the wall. At the end, is in painted or papered, as you like it. Typically, an external wall with hypocaust elements is sufficient per room. This system is the ideal replacement for thermal storage and a very good solution for the energy optimisation of buildings – E.g. with natural stone facades, with timber-frame houses. This principle establishes thermal comfort in homes with lower energy consumption than a convection heating with panel radiators or radiators. The wall surface heated to approx. 25 C over the entire surface emits thermal radiation in the area, which heats all illuminated items as a result it is Temperature of the surface of cover.

LUBRICATION

A valve EGR not operating properly can result in problems of detonation or pre-ignition. Notes on the thermostat a thermostat function is to prevent water from flowing into the motor while this has not reached its operating temperature, in accordance with the manufacturer’s specifications. When the engine temperature nears its (normally 80 C) operating temperature, thermostat begins to open up letting some water to mix with the hot water and start the cooling process. When the engine warms up fully, the thermostat opens to fullness, controlling the speed of water circulation. It is common to be withdrawn the engine thermostat to believe that motor should operate as cold as possible. Some even argue that you split will head when the thermostat opens and lets the cold water. Nothing could be farther from reality.

The problem deleting the thermostat more critical with the conversion of the engine returns to LP Gas. When the gas engine works below 80 C, the Pistons and the valves are filled with white deposits by the nitration of the oil. Operate an engine under its operating temperature forces to turn to an excessive consumption of fuel, causing damage in valves, rings and the catalytic converter, among other components. SYSTEM of LUBRICATION pump and oil pump strainer and the oil strainer must be new always install a remanufactured engine, (consider that it is impossible to perfectly clean a colander). Arrow of some oil pump are heavy and manufactured in forged steel; others have very small diameters and therefore wear out, bend and break more easily. A worn arrow can not only damage your own gear but also the gear pump.

Don’t risk an engine remanufactured by wanting to save a few pesos. Always replace the arrow. Oil cooler Optional accessory which consists of a small radiator that is located in the middle of the oil passage and located either within the main radiator of the vehicle or at the forefront of this.